Amada MM-L300A, Original Instructions Manual

Page: 57 / 180

MM-L300A
6. How to Operate the PC Software
6-16
No. Item Description
(1) Status display The connection state with the
MM-L300A
is displayed.
Online: Indicates that connection between this application and
the
MM-L300A
is established.
Offline: Indicates that this application and the
MM-L300A
are
not connected.
(2) Condition
Number
The condition number (00 to 63) selected on the Condition Select
Window is displayed.
(3) Unit ID The unit ID number set in the connected
MM-L300A
is
displayed. It can be changed on the Maintenance Window.
(4) Measurement
Time
Sets the time required for obtaining a waveform of the
MM-L300A
(data sampling period after trigger-on) in the range
of 1 to 999 (only integers). Also, set the unit of time (sec, msec,
usec).
Since the graph, integral settings and local parameters are
initialized when the setting is changed, the confirmation window
appears.
(5) Sampling Freq
Data Points
According to the measurement time set in [Measurement Time],
data sampling cycle and the number of samplings (up to 3000
points can be set) are automatically displayed.
(6) Comment Displays and sets the comment of the condition.
If nothing is input, [Condition XX (XX part is the condition
number)] is input when saved. Also, "," (comma) cannot be used.
(7) Set Condition Specifies the Upper Limit and the Lower Limit of the range set in
[Edit Start Point] and [Edit End Point] in the unit of %. (1%
≒
graph intensity scale × 1/100) Sets by key input or [+]/[-] button.
(8) Ratio setting:
Threshold
Sets the judgment threshold. The lower limit judgment value
lower than this threshold becomes invalid. Sets by slide bar or
[+]/[-] button. (Refer to
(1) Threshold .)
Direct setting:
Start point / End
point Sets the intensity of Edit Start Point and Edit End Point. Sets by
slide bar or [+]/[-] button.
(9) Setting mode Ratio setting: Sets the upper/lower limit judgment value of the
judgment condition at a ratio.
Direct setting: Sets the upper/lower limit judgment value of the
judgment condition at an arbitrary value. Set upper limit and
lower limit, respectively. Upper limit and Lower limit can be
selected from the combo box.
* From the reference waveform type selecting combo box,
waveforms of Average, Range and 3
σ
can be switched and
displayed. However, you need to select waveform and perform
calculation on the Basis Waveform Calculation Window in
advance.
(10) Waveform
display
The waveform calculated on the Basis Waveform Calculation
Window and the upper/lower limit judgment value are displayed.
Threshold is also displayed in the ratio setting.
(11) Edit Start Point Sets the point to start editing. Sets by slide bar or [+]/[-] button.
(12) Edit End Point Sets the point end editing. Sets by slide bar or [+]/[-] button.
(13) dig The resolution of the condition setting period of [Edit Start Point]
and [Edit End Point] is displayed. When fractions are set in
[Measurement Time], it shall be rounded off.