MM-L300A
9. Interface
9-5
(4) ANALOG OUT
This connector can output an analog signal with 0 to 5 V.
Pin No.
Description
1
0-5V OUT (ANALOG OUT+ (out))
The value which an incident light is converted into voltage is output.
2
Analog GND (ANALOG OUT- (out))
When measuring pin No.1, connect to the GND on the measuring side.
3 Unused
Do not connect anything.
4 Unused
Do not connect anything.
(5) LAN
This is a connector to make a connection with a personal computer.
This connector can output the data and waveform data measured by the
MM-L300A
.
(6) POWER
This is a connector to make a connection with the
MM-L300A
(6-pin).
By connecting it to the TRIGGER connector of the
MM-L300A
with the attached
external trigger unit connecting harness, the power can be supplied and the external
trigger signal can be input.
* Since this unit uses the TRIGGER connector of the
MM-L300A
, pin Nos. 5 and 6
of the TRIGGER connector of the
MM-L300A
are disabled. When using the
MEASURE signal, use pin Nos. 7 and 8 of the MEASURE connector (10-pin).
4 1
3 2
Summary of Contents for MM-L300A
Page 1: ...AA04OM1193911 18 OPERATION MANUAL Original instructions LASER WELD MONITOR MM L300A...
Page 78: ...MM L300A 6 How to Operate the PC Software 6 37 Lower limit line Upper limit line...
Page 97: ...MM L300A 6 How to Operate the PC Software 6 56 2 Click Advanced settings 3 Click Inbound Rules...
Page 180: ......
