Amada MM-L300A, Original Instructions Manual

Page: 14 / 180

MM-L300A
4. Name and Function of Each Part
4-2
(2) Rear
(1) Power switch:
Turns the power ON/OFF.
(2) AC INPUT:
Used to connect the attached power cord to supply power.
(3) LAN:
Used to connect to the personal computer with the attached LAN cable.
(4) ANALOG OUT:
Outputs the
SU-N300A/SG-N300A
detection with the analog signal. It can be
observed with an oscilloscope, etc. [Digital Gain] and [Offset] on the Maintenance
Window are not reflected.
(5) TRIGGER:
Controls the measurement start by inputting the external trigger. Also, outputs the
signal of MEASURE. This connector is also used when the optional external trigger
unit is used.
(6) SENSOR:
Used to connect the
SU-N300A/SG-N300A
with the selected sensor unit
connecting cable.
(7) EXT. I/O:
Connector for input and output with the external device.
(8) ANYBUS (option):
Terminal for external network. Used when the optional EtherNet/IP is used. (Refer to
11. EtherNet/IP .)
(1)
(8)
(7)
(6)
(5)
(4)
(3)
(2)