Amada MM-L300A, Original Instructions Manual

Page: 151 / 180

MM-L300A
11. EtherNet/IP
11-6
# Data name Data type Access Data contents
7 Wave Data UINT array [16] Get Waveform data last obtained (header part)
[0]: Waveform attribute
[1]: Number of data points
[2]: Number of moving averages (high-order
8 bit), number of skips (low-order 8 bit)
[3]: Sampling cycle
μ
s (low-order 16 bit)
[4]: Sampling cycle
μ
s (high-order 16 bit)
[5]: Value of Time 16 to 0 bit (UNIX time
format, in the unit of
μ
s)
[6]: Value of Time 31 to 17 bit
[7]: Value of Time 47 to 32 bit
[8]: Value of Time 63 to 48 bit
[9]: Integrated value (low-order 16 bit)
[10]: Integrated value (high-order 16 bit)
[11]: Minimum value
[12]: Maximum value
[13]: Measured condition setting number
[14] to [15]: (Reserve)
8 Condition UINT array [16] Get Settings of current condition (header part)
[0]: Reserve
[1]: Number of data points
[2]: Resolution
μ
s (low-order 16 bit)
[3]: Resolution
μ
s (high-order 16 bit)
[4]: Sampling cycle
μ
s (low-order 16 bit)
[5]: Sampling cycle
μ
s (high-order 16 bit)
[6]: Sensor unit analog gain
[7]: Number of moving averages (high-order
8 bit), number of skips (low-order 8 bit)
[8] to [15]: (Reserve)
9 Condition No USINT Get/Set Currently set condition number
(For Set, the setting is reflected when the
Condition Cntl is local.)
10 Condition Cntl USINT Get/Set Change source of condition setting
0 = Remote (external DI switching)
1 = Local (other than external DI)
11 Trigger Mode BOOL Get/Set Trigger mode
0 = External
1 = Internal
12 Wave Count UDINT array [4] Get/Set Waveform count
[0]: High-order 32 bit of TOTAL count
[1]: Low-order 32 bit of TOTAL count
[2]: High-order 32 bit of NG count
[3]: Low-order 32 bit of NG count
13 Unit ID UINT Get Unit ID
14 IP Address USINT array [4] Get IP address setting of the
MM-L300A
(LAN
connector)
15 Subnet Mask USINT array [4] Get Subnet mask setting of the
MM-L300A
(LAN connector)
16 Gateway Address USINT array [4] Get Default gateway setting of the
MM-L300A
(LAN connector)