MD Series
7. Basic Operation
7-3
⑧
Next, select PRECHECK and press the ENTER key.
Set the precheck ON/OFF and precheck conditions.
Operation on the PRECHECK screen is now complete.
Press the MENU key to return to the menu screen.
⑨
Select SCHEDULE and press the ENTER key.
⑩
Move to the welding test. Perform the actual welding and check to see if the welding
schedule is set correctly.
Press the MENU key and return to the menu screen.
Next, select COMPARATOR, and press the ENTER key to go to the COMPARATOR
screen.
⑪
Press the WELD key on the front panel to turn the WELD lamp on.
To turn ON the WELD key, hold it down for approx. 1 second.
⑫
Turn on (close) the WELD ON/OFF of the control signal terminal strip on the rear
panel.
Check that the READY lamp on the front panel is on.
The READY lamp comes on when the WELD lamp on the front panel comes on
and Terminals 15 and 16 (WELD ON/OFF) of the control signal terminal strip on
the rear panel are closed.
It goes out when a fault occurs, welding, or charging.
⑬
Input the schedule-select signal.
Turn on (close) SCH1/SCH2/SCH4/SCH8 (as well as PARITY) of the control signal
terminal strip on the rear panel to select schedule No.15.
→
Set the schedule No. to 15.
→
Set the weld time for precheck at 0.50 ms.
→
Set the voltage to 1.00 V.
Set the range of precheck.
(Set a wide range here.)
→
Use the precheck function.
→
Set the schedule No. to 15.
. Set the current and voltage.
. Set the weld time.
Summary of Contents for MD-A8000B-05 Series
Page 95: ......
