Altigen AltiWare OE 4.0, Administration Manual

Page: 88 / 238

Trunk Configuration
78 AltiWare OE System Administration Manual
Triton T1/PRI Trunk Properties
To configure a Triton T1/PRI channel, select a Triton T1/PRI channel from
the trunk channels list in the Trunk Configuration window, then click the
Trunk Properties button or double-click the list entry to view the Triton
T1/PRI Trunk Line Properties dialog box.
Figure 29. Triton T1 Configuration dialog box
T1 robbed-bit signaling
You can set the Protocol to one of the following E&M Wink Start
(default), E&M Immediate Start, Ground Start or Loop Start.
For signaling from one board to another, only FXS (Foreign Exchange
Subscriber) is supported. Loop Start and Ground Start protocols cannot be
used for interfacing between two boards.
The Dialing Delay specifies the delay, in milliseconds, after trunk seizure
and before digit dialing. Do not change this value unless advised.
Caller ID and DID Collection
You can select the maximum time-out delays, in seconds and the
appropriate sequence of symbols to be collected for Caller ID and DID.