Altigen AltiWare OE 4.0, Administration Manual

Page: 89 / 238

Setting General Trunk Attributes
AltiWare OE System Administration Manual 79
Tru
n
k
C
o
nf
igur
a
tio
n
The Max. seconds before the first digit setting is the maximum wait time
before time-out for the system to identify this digit after either the first ring
in ground start or loop start or the wink in wink start. The range is from 1 –
6 seconds, or None, with a default value is 3 seconds. Do not change this
value unless advised.
‘None’ means no Caller ID or DID information will be collected. All other
options will be grayed out. Use this option to disable Caller ID and DID
collection.
The Max. seconds between digits - maximum wait time before time-out
between two digits. Default value is ‘None.’ Do not change this value
unless advised.
Selecting ‘None’ means the system will only wait for the sequence of digits
that are collected within the length of time specified in the Max. seconds
before the first digit field.
Check the Incoming sequence check box: and select up to five incoming
symbols to collect from the Caller ID or DID digits:
• None
• #
• *
• # or *
• Caller ID
• DID/DNIS
Selecting ‘None’ in any field of the sequence will terminate the
sequence and automatically disable subsequent entries in the sequence.
The following default sequence is enabled, as shown in Figur e29:
(a n d th e n ) (a n d th e n ) (a n d th e n )
To set up an additional, alternative sequence, check the Or check box and
select an another set of up to five incoming symbols to collect.
Not checking any box is equivalent to checking ‘None’ in the first field.
— If appropriate, you can use the Apply to… button, as described
on page 71, to apply the Caller ID Collection to multiple T1 trunks.