Agilent Technologies 4339B, Operation Manual

Page: 207 / 287

4339B Measuring Resistivity of Insulation Materials
7. Turn the load knob to apply pressure by the upper and lower electrodes on the DUT , and
then close the top cover .
Turning load knob applies load pressure on the DUT of up to approximately 10 kg. If you
do not need to apply a specic pressure , DUT must at least rmly held by the upper and
lower electrodes .
8. Set the resistivity cell parameter
a. Press .
b. Enter DUT thickness .
Select Thickenss using or and press . Enter the thickness value , for
example 0.13 (mm), and press .
c. Select the resistivity cell size .
Select ResCell using or and press .
Select 50 (mm) using or , and press twice .
d. Select Exit and press to exit.
9. Set the measurement sequence conguration.
Press . Select Charge and press . Enter the charge time , for example 60 (s),
and press twice .
10. Select the single mode as the measurement sequence mode .
Press . Select Single using or and press .
Application Measurement 6-7