Aficio 3228C, Operating Instructions Manual

Page: 797 / 1150

Using Administrator Settings
163
9
❒
When you wish to change the end
receivers depending on the for-
warding destinations, specify the
end receivers by the forwarding
destinations, at “Special Senders”.
A document received from a for-
warding destination who has not
been specified as the end receiver
will be forwarded to the forward-
ing destination that has been spec-
ified in this function. See p.171
“Special Senders to Treat Differ-
ently”
❒
You can specify whether or not to
print forwarded messages. See
p.166 “User Parameters” (switch
11, bit 6).
❒
Deleting a destination specified as
a forward destination from the
destination table causes the set-
tings of the forward destination to
be deleted, so they must be regis-
tered again. When a destination is
changed, a message is transmitted
to the new destination. If there is
no destination of the specified
type, you can set to have a certain
destination quoted with priority.
See p.166 “User Parameters”
(switch 32, bit 0).
❒
You can program one of the Quick
Operation keys with operations for
this function. See p.144 “General
Settings/Adjustment”.
❒
If you have specified a folder for
forwarding, you can specify the
file format used for forwarding.
See p.166 “User Parameters”
(switch 21, bit 3).
Programming an End Receiver
AAAA
Press the
{{{{
User Tools/Counter
}}}}
key.
BBBB
Press
[ Facsimile Features ]
.
CCCC
Press [ Administrator Tools ] .
DDDD
Press [ Forwarding ] .
EEEE
Press [ On ] .
Limitation
❒
One end receiver can be regis-
tered per a special sender. To
register two or more end receiv-
ers, use Group Destination.
However, a maximum of 500
parties can be specified in a
group.
Note
❒
If there is an End Receiver al-
ready programmed, a receiver
name is shown. If you want to
change the receiver, press
[ Re-
ceiver ] and proceed to step
F
.
❒
To cancel Forwarding, press
[ Cancel ] and proceed to step
H
.
JupterC2_Fax_AE-F_FM.book Page 163 Monday, December 13, 2004 2:32 PM