Installation Manual for digital sets - IP sets - SIP sets
AMT/PTD/TR/0001/3/7/EN
To install sets and cartridges in the i7XX range
05/2008
Page
5-57
the sleeve.
•
Fit the IP cartridge into its slot, and secure it (3 securing screws).
•
Lift the cover then connect the cartridge link to the set connector.
•
Close the cover.
•
Remove the two covers on the rear panel by pushing them outwards from the inside.
•
Refit the set's rear panel (3 screws).
•
After removing the protection, fit the adhesive window at the location of the covers, opposite the
connectors.
•
Fit the various connections: LAN, power supply unit and PC, if required.
Nota :
Do not connect anything to the Line connector.
5.9.3.4
IP cartridge identification
The IP cartridge has an internal factory-set MAC address, which cannot be modified. A label
indicating this address is supplied in the cartridge package.
Fit the label that identifies the cartridge's MAC address on the back of the set in which it is fitted, in
the bottom left corner on the extension connector side.
The IP cartridge has a unique factory-set identification number (CPEID) that cannot be modified.
