TMA Grand Master 3.2 – User’s Guide
4 Operating the Main Unit
2. For tte recipient blocks (
1
) click tte
(Channe Blocks)
buton next to tte image of tte
specifc block pairs. Depending on tte donor block tray ttat you want to rotate to insertng
positon, click tte tray ID:
A
–
F
(
2
). Alternatvely, if tte new view is actvated, click
Insert
Block
(
3
) on tte Unused Block(s) panel if you want to insert a new recipient block, and click
Insert
(
4
) at tte donor panel to insert new donor block into tte donor block tray selected
automatcally by tte sofware.
3. Tte donor/recipient block tolder cylinder turns to tte loading positon witt its appropriate
side. Tte ID of tte corresponding tray is marked witt green, also tte slot is lit for easier
identfcaton.
4. Tte door opener buton turns green (buton status is stown at tte rigtt side of tte main
toolbar). Tte ligtt pulsates for about 10 seconds and it is possible to open tte door wittin
ttis tme frame (countdown is displayed in place of tte buton).
5. Pust tte door opener buton to open tte door.
6. Press down tte nap in front of tte block slot.
7. Slide tte block into positon witt tte slanted side towards tte back of tte mactine.
8. Release tte nap wten tte block is in positon.
9. Close tte door.
10. Tte column turns into tte next positon, tte teigtt of tte inserted block is measured (also,
tte presence of tte block is ctecked). Ttese data are saved for later use (for drilling,
puncting operatons, and deptt of inserton) and based on tte measurements, tte sofware
calculates tte distance of tte objectve from tte surface of tte recipient block in order to
take an accurate ptoto of it.
11. Follow tte steps 1-9 if you want to insert additonal blocks into otter trays. If tte cylinder is
at tte proper positon, it is not necessary to tte click tte tray ID tten tte
buton.
August 6, 2020 – Rev. 1
3DHISTECH Ltd.
31(116)
3
4
