Wilo Stratos GIGA2.0-D, Инструкция по установке и эксплуатации

Страница: 168 / 552

en Electrical connection
168 WILO SE 2021-12
Connection Terminal cross-sec-
tion
in mm
2
Min.
Terminal cross-sec-
tion
in mm
2
Max.
Cable
Electrical mains connec-
tion ≤ 4 kW:
4x1.5
> 4 kW:
4x2.5
≤ 4 kW:
4x4
> 4 kW:
4x6
SSM 2x0.2 3x1.5 (1.0**)
changeover relay *
SBM 2x0.2 3x1.5 (1.0**)
changeover relay *
Digital input EXT. OFF 2x0.2 2x1.5 (1.0**) *
Digital input EXT. MIN/
EXT. MAX 2x0.2 2x1.5 (1.0**) *
Analogue input 1 2x0.2 2x1.5 (1.0**) *
Analogue input 2 2x0.2 2x1.5 (1.0**) *
Analogue input 3 2x0.2 2x1.5 (1.0**) *
Analogue input 4 2x0.2 2x1.5 (1.0**) *
Wilo Net 3x0.2 3x1.5 (1.0**) Shielded
CIF module 3x0.2 3x1.5 (1.0**) Shielded
Table 10: Cable requirements
*
Cable length ≥ 2 m: use shielded cables.
**
When using ferrules, the maximum cross-section at the terminals of the communica-
tion interfaces is reduced to 0.25 ... 1 mm².
In order to comply with electromagnetic compatibility standards, the following cables
must always be shielded:
ƒ
Cable for EXT. OFF/MIN/MAX at digital inputs
ƒ
Temperature sensors at analogue inputs
ƒ
External control cable sensors at analogue inputs
ƒ
Differential pressure sensor (DPS) at analogue inputs, if installed on-site
ƒ
Twin-head pump cable with two single pumps in the Y-piece (bus communication)
ƒ
CIF module to the building automation (bus communication)
The shield is connected to the cable bushing on the electronic module. See Fig. 24.
Terminal connections
Terminal connections for all cable connections in the electronic module correspond to
push-in technology. They can be opened with a screwdriver type slot SFZ 1 –
0.6 x 0.6 mm. Exception: Wilo-Smart Connect Module BT.
Length of cable to strip
The stripping length of the cables for the terminal connection is 8.5 mm ... 9.5 mm.