Wilo Stratos GIGA2.0-D, Инструкция по установке и эксплуатации

Страница: 147 / 552

Description of the pump en
Installation and operating instructions Wilo-Stratos GIGA2.0-I, Wilo-Stratos GIGA2.0-D 147
Fig. 1: Pump overview
Item Name Explanation
1 Transport lugs Used for transporting and lifting the components. See
“Installation” [
} 152] section.
2 Pump housing Installation according to “Installation” section
3 Motor Drive unit Forms the drive together with the electronic
module.
4 Graphic display Provides information about settings and pump status.
Self-explanatory user interface for setting the pump.
5 Electronic module Electronic unit with graphic display.
6 Electrical fan Cools down the electronic module.
7 Protective plate in
front of lantern
window Protects against rotating motor shaft.
8 Slot for Wilo-Smart
Connect Module
BT Wilo Connectivity Interface as slot for the Bluetooth
module
9 Differential pres-
sure sensor 2 ... 10 V with capillary tube connections on flanges of
suction and discharge side
Table 2: Description of the pump
ƒ
Item 3: the motor with mounted electronic module can be rotated relative to the
lantern. Observe the instructions in the “Permitted installation positions and
change of the arrangement of components before installation” [
} 154] section.
ƒ
Item 4: the display can be rotated in 90° steps as required (see section “Electrical
connection” [
}
165]).
ƒ
Item 6: an unobstructed and free air flow must be ensured around the electric fan
(see “Installation” [
} 152] section).
ƒ
Item 7: the protective plate must be dismantled for the leakage check. Observe the
safety instructions in “Commissioning” [
}
176] section!
ƒ
Item 8: for installing the Wilo-Smart Connect Module BT, see “Installation Wilo-
Smart Connect module BT” [
} 175] section.
Rating plates (Fig. 2)
2
1
Fig. 2: Rating plates
1 Pump type rating plate 2 Drive type rating plate
ƒ
There is a serial number on the pump type rating plate. It must be specified e.g. for
ordering spare parts.
ƒ
The drive type plate is located on the side of the electronic module. The electrical
connection must be designed according to the specifications on the drive type rat-
ing plate.
Functional modules (Fig. 3)
Fig. 3: Functional assemblies
Item Name Description
1 Hydraulic unit The hydraulic unit consists of pump housing, impeller
and lantern.
2 Differential pres-
sure sensor (op-
tional) Differential pressure sensor with connection and fixation
elements
3 Drive The drive consists of a motor and an electronic module.
4 Motor
5 Electronic module Electronic unit
6 Impeller