Weather-Rite TT Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 186 / 205

TT-S
ERIES
I
NSTALLATION
, O
PERATION AND
S
ERVICE
M
ANUAL
180 of 198
27. 8 .4.2 MP2+ System
Initial Men u programming, press once. Programs appears, press or scroll to Glo b al Settings and
press .
Programs selected:
• Scroll to desired Program #, press .
• After program loads, scroll to Process men u , Operational men u or Diagnostic Men u and press .
• Proceed to selected Men u to contin u e programming.
Glo b al Settings selected:
• Scroll to Operational men u or Diagnostic Men u , press .
• Process to selected Men u to contin u e programming.
For Process Men u programming See Page 178, Table 47 . For Operation Men u programming, See Page 178,
Table 48
For Diagnostic Men u programming, See Page 179, Table 49 .
3 Maxim u m Temp Process #, scrol to Set Points #, press .
4 Max T Proc #, set Temp v al u e (60 °F (15 °C) to 240 °F (115 °C), press .
5 **Stored** w ill flash 4 times to confirm entry.
6 Repeat steps 2 - 5 for Set Points #(2-8)
Min Proc Temp (Glo b al Setting for MP2+ system)
2 Scroll to Min Proc Temp, press .
3 Min Proc Temp, set Temp v al u e (60 °F (15 °C) to 240 °F (115 °C)), press .
4 **Stored** w ill flash 4 times to confirm entry.
Calibration
2 Scroll to Cali b ration, press .
3 cali b ration Process #, scroll to Set Point #, press .
4 Cal Proc #, set Temp v al u e (-10 °F (-5.6 °C) to 10 °F (5.6 °C)), press .
5 **Stored** w ill flash 4 times to confirm entry.
6 Repeat steps 2 - 5 for Set Points #(2-8)
Monitor
2 Scroll to Monitor, press .
3 Monitor, set On or Off, press .
4 Either monitor mode on or Off w ill flash 3 times to confirm entry.
Loopin g (Glo b al Setting for MP2+ system)
2 Scroll to Monitor, press .
3 Scroll to READY or FIRST PROCESS, press .
4 **Stored** w ill flash 4 times to confirm entry.
F/C Mode (Glo b al setting for MP2+ system)
2 Scroll to F/C Mode, press .
3 F/C MODE, scroll to either Fahrenheit or Celsi u s, press .
4 **Stored** w ill flash 4 times to confirm entry.
NOTE: Changing b et w een F and C w ill ca u se the MP2 system to reset to factory defa u lts.
Software Version (Glo b al Setting for MP2+ system)
2 Scroll to Men u Soft w are Version, press .
3 Soft w are Version information w ill appear.
ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
PGM
ENT
ENT
ENT
ENT
ENT