USTER HVI1000, Инструкция по эксплуатации, Страница: 190 / 238

USTER®
HVI 1000
Instruction Manual
Uster Technologies, Inc. Chapter 10
(3/08) Maintenance
-
Page 10-4
Fingerprints can usually be seen on tile sets by holding the tile up
and looking at the reflections given off the tile set. Fingerprints, if
left on a tile set for a period of time, will turn yellow and thereby
shift the color calibration.
•
Handle the tiles only on the edges by stretching the fingers across
the back-side of the tile and grasping the edges. Never handle
the tiles in a manner that will place fingerprints on the color
surface.
•
Uster recommends the tile set be cleaned on a periodic basis,
depending upon use and conditions. Usually every 2 to 3 months
is sufficient.
4.1 Cleaning Calibration Tiles
Use care when handling, using or cleaning the tile set. To clean the tile
set,
1. Use a small amount of dish liquid in about ½ gallon water.
2. Using the soap mixture, use a soft cloth to thoroughly clean all
fingerprints from the surface of both sides of each tile.
3. Do not touch the color surface once the cleaning has been done.
4. Thoroughly rinse the tile with warm water taking care to remove
all soap and residue.
5. Thoroughly dry both sides of the tile with a soft cotton cloth.
6. These tiles are very porous and should be allowed to dry for a
period of at least 24 hours before next use.
7. After the 24 hour drying period, it is recommended that they be
buffed again with a clean cotton cloth.