USTER HVI1000, Инструкция по эксплуатации

Страница: 112 / 238

USTER®
HVI 1000
Instruction Manual
Uster Technologies, Inc. Chapter 6
(3/08) System Testing
-
Page 6-18
5. Place the remaining part of the left bale cotton sample into the
rear of the color/trash tray.
6. Enter the Bale ID for the right cotton sample.
7. Place 8-10 grams of cotton from the right bale cotton sample into
the
right drum.
8. Place the remaining part of the right bale cotton sample into the
front of the color/trash tray.
9. Press the L/S Start button
(on the L/S cabinet)
.
10. Press the C/T Start button
(on the Mic cabinet)
.
11. Remove the left bale cotton sample from the balance and place it
into the micronaire chamber. Close the MIC door to measure the
micronaire value for the
left bale cotton sample, or if Manual Mic
Entry is checked, skip this step.
12. Weigh approximately 10 grams of cotton from the right bale
cotton sample using the balance. Remove the cotton from the
balance and place it in the micronaire chamber. Close the MIC
door to measure the micronaire value for the
right bale cotton
sample, or if Manual Mic Entry is checked click Enter Mic and
enter the value.
13. If the selected number of color/trash reading is two (suggested),
then when the first pair of measurements is completed,
turn over
both cotton samples (within their respective trays) and press the C/T
Start button again
(on the Mic cabinet)
.
As the tests are completed for the cotton sample, the results are
displayed on the screen and transmitted to the host
(if testing online)
.
Data will remain on the screen until testing of the next pair of bales
begins (enter Bale ID for next left cotton sample).
7.2 Retesting
Once data is collected and the summary of data is displayed, a bale
with discrepant data (or data that appears to be incorrect) can be
retested by re-entering the Bale ID and repeating the testing cycle. Initial
information from a retested bale will be overwritten when transmitted to
the host, or when it becomes part of the testing report.