Uniflair UST500, Инструкция по эксплуатации

Страница: 13 / 100

UST500 CONTROL BOARD
06MC0074@00B0100
14/04/2010
13
default configuration
LEDs for utilities are all configurable (see parameters chapter, folder Ui). The factory settings are listed in the table below:
LED symbol
on display LED Default
Default icon
on front panel
LED 1
(first from left)
Compressor 1
LED 2 Output step 2
LED 3 Internal exchanger electric heater 1
LED 4 Internal exchanger electric heater 2
LED 5 Boiler
LED 6 External exchanger fan
LED 7 Internal circuit water pump
First switch on
set
esc
When UST500 is switched on for the first time, a
lamp test is carried out to check the state and
proper function of lamps.
----------
The Lamp Test lasts for a few seconds. During this
short time, all LEDs and digits flash at the same
time.
set
esc
After the lamp test, based on preselected settings,
the following are displayed:
•
time,
•
real setpoint
•
parameter setpoint
•
the value of the analogue input selected
(AI1…AI4)
----------
In the example, the current time is the main display
(RTC)
Access to folders - menu structure
Access to folders is organised into menus.
Access is determined by the keys on the front panel (see relative sections).
Access to each individual menu is explained below (or in the sections indicated).
There are 4 menus:
•
‘Main Display’ menu
→
see ‘Main Display Menu’ section;
•
‘Operating Mode’ menu
→
see ‘Operating Mode Menu’;
•
‘States menu’
→
see "States Menu’ section;
•
‘Programming Menu’
→
see ‘Programming Menu’ section.
There are 4 folders/submenus in the Programming Menu:
•
Parameters Menu (Par folder)
→
see Parameters chapter
•
Functions Menu (Fnc folder)
→
see Functions chapter;
•
Password PASS
•
Alarm codes EU