Page 48
T47541109 Rev. J
FlexJet Head Assembly
TECHNICAL
PUBLICATIONS
This Document Supports Assembly 47541109 Rev. F
3.
Manually move the selected spindle down so that both Pin Mirrors are
accessible. Refer to the following diagram.
A
View A
Do not dry wipe the Pin Mirrors or scratching may occur. Also, it is not
recommended to use denatured alcohol, which has a high level of
contaminants compared to isopropyl alcohol.
Using swabs with visible contamination can damage the Pin Mirrors. So
check the swab tips frequently and discard a swab when contamination
is evident.
4.
Moisten a lint-free swab (ESD Swab) with Isopropyl alcohol or a
solution approved for use on sensitive optical surfaces and roll the head
of the swab between the fingertips, unless the swab has a foam tip. The
swab should be at least 6 inches (152,4 mm) long. Refer to the
following diagram.
Swab
5.
While holding the Spindle in the down position so that the opening in
the Spindle housing is accessible, clean both Pin Mirrors by pushing
the alcohol-moistened cotton swab through the openings in the spindle
Housing. Refer to the following diagram.
Clean both Pin Mirrors by inserting swab
through Spindle Housing openings.
Pin M
irror
s
