Page 89
FlexJet Head Assembly
T47541109 Rev. J
TECHNICAL
PUBLICATIONS
This Document Supports Assembly 47541109 Rev. F
9.
Disconnect the clutch wire of the clutch to be replaced from the PCA
Flex Jet Control. Refer to the following diagram.
Head Control
Asm PC BD
32PL (P32) Z Encoder Assy
6PL (P6) Clutch 4
9PL (P9) Clutch 7
5PL (P5) Clutch 3
4PL (P4) Clutch 2
8PL (P8) Clutch 6
12PL (P12) Mirror Clutch
3PL (P3) Clutch 1
7PL (P7) Clutch 5
10PL (P10) Z Stop Clutch
10.
Clean the clutch shaft with denatured alcohol or equivalent using a
clean, white cloth.
11.
Remove the cable clamp from Mirror Clutch. Remove the screw and
hex nut from the pulley on the clutch assembly.
The pulley cannot be removed from the clutch shoe, so a new pulley will
be needed for each clutch removed.
12.
Clean the inner diameter of each clutch solenoid and clutch shoe with a
cue tip swab or equivalent.
13.
Check each clutch assembly to make sure the clutch shaft rotates freely
within its diameter.
14.
Apply Loctite 222 to the screw removed in step 11 and reassemble the
screw into cable clamp and hex nut.
Install the New Clutch
1.
Connect the clutch wire to the PCA Flex Jet Control.
2.
Remove the set screws from the new clutch assembly.
3.
Replace the defective clutch, verifying that all spacers have been
installed correctly.
