Page 44
T47541109 Rev. J
FlexJet Head Assembly
TECHNICAL
PUBLICATIONS
This Document Supports Assembly 47541109 Rev. F
f.
Select the
Tool #
of the spindle just returned to the home
position.
g.
Select
SPINDLE_CLUTCH
in the
Select Outputs
field.
h.
Select
Reset Outputs
to disengage the clutch.
6.
Repeat the entire Sensor Setup section for any other spindle touch-
down sensors which need adjustment. If necessary, refer to
information recorded during the Verifying the Touch-Down Sensors
section of this document. Make sure to change the
Tool #
to match the
number of the selected spindle.
When all touch-down sensors selected for setup are properly adjusted,
proceed to the Setup Verification section.
Setup Verification
Perform the following procedure to verify the sensors after adjustment.
The fixture must be removed from the Coupler Body Assemblies before
head use to prevent head damage.
1.
Palm up and zero the machine. Refer to the Machine Operation
document for information on zeroing.
2.
Perform the Verifying the Touch Down Sensors procedure in this
module. If all 7 spindles are properly adjusted, proceed to step 3.
Otherwise, repeat the Sensor Setup section for any spindles that are still
not adjusted correctly.
3.
Use
Manual Control
to move the head to an accessible location.
4.
Install the feeders that were removed earlier in the procedure. If
necessary, verify that the software feeder configuration is correct.
Refer to the Feeder Configuration document in the Product Editor
Guide.
5.
Install the FlexJet Head Cover and install the safety cover below the
hinged cover.
Spindle Height Calibration must always be performed after Touch-Down
Sensor Setup on a FlexJet Head.
6.
Perform Spindle Height Calibration. Refer to the Spindle Height
Calibration section of the Calibration, CPE, and Measurement manual.
