Page 61
FlexJet Head Assembly
T47541109 Rev. J
TECHNICAL
PUBLICATIONS
This Document Supports Assembly 47541109 Rev. F
7.
Rotate a Z Driven Pulley clockwise until the Stop Bracket comes in
contact with the Head MNT Platform. Refer to the following diagram.
If the Stop Brake is still engaged, the Z Driven Pulleys will not rotate.
Z Driven
Pulleys
Stop
Bracket
Head MNT
Platform
8.
Highlight
STOP_CLUTCH
located in the
Select Outputs
field.
Select the
Reset Outputs
button.
9.
Select
Exit
.
Verify the Z Safe Sensor Signal
Use the following steps to set up the Z Safe Sensor so that the sensor is on
when all 7 spindles are in the up position.
Glare from the bottom of the PC Board may cause Z Safe to be on in
multiple positions. This may indicate that the emitter and/or receiver are
not completely aligned to each other (parallel to the Optic Bracket).
