Page 25
FlexJet Head Assembly
T47541109 Rev. J
TECHNICAL
PUBLICATIONS
This Document Supports Assembly 47541109 Rev. F
6.
Turn the locking knob clockwise until the pressure adjustment knob
locks. Verify that the pressure is still 85 psi (5,86 bar). If the pressure
is not 85 psi (5.86 bar), repeat from step 6.
Pneumatic Panel
Assembly
Center Rear Cover Assembly Handle
Center Rear Cover Assembly
Install the Panel and Covers
1.
Carefully push the Pneumatic Panel Assembly into the machine and
engage the panel locking lever.
Do not force the Pneumatic Panel Assembly into the machine. This may
cause damage to the electrical or pneumatic connections of the
assembly.
2.
Check for damaged or crimped wires and pneumatic lines. Make any
changes to the orientation of the wires or pneumatic lines to maintain
proper operation of the Pneumatic Panel Assembly.
3.
Attach the rear (cooling fan) panel with the two screws that were
removed earlier.
4.
Install the Center Rear Cover Assembly on the machine. Continue
with the next section to prepare the machine for vacuum verification.
Lower the Spindles
Prepare the machine for vacuum verification using the following procedure.
1.
Zero the machine. Refer to the Machine Operation document for more
information.
2.
Select
System Setup > Machine > Setup > Head/Changer
Nozzle Setup
and lower the spindles.
Refer to the Installation/Removal of Nozzles section of the Spindle
Assembly document . If necessary use the
Manual Control
button to
move the beam to an accessible location.
