Page 66
T47541109 Rev. J
FlexJet Head Assembly
TECHNICAL
PUBLICATIONS
This Document Supports Assembly 47541109 Rev. F
4.
Move the weight to the next spindle and repeat from step 2. When all 7
Spindle belt tensions are verified and/or adjusted, continue with the
Final Steps section.
Final Steps
1.
Remove the Z Belt Tension Tool.
2.
Install the FlexJet Head. Refer to the Installing a FlexJet Head
procedure located in this document.
3.
Complete the steps in the Prepare the Machine for Production section
of this document to ensure that the machine is in a safe operational
state. Verify that all covers removed for maintenance are installed,
including the safety covers below the hinged covers.
4.
Perform Calibration Placement Enhancement (CPE). Refer to the
Calibration, CPE and Measurement manual.
Adjusting the Stop Brake Belt Tension
Set the Stop Brake belt tension after replacing the Stop Brake, the stop
clutch, or the Stop Brake belt using the following procedure.
1.
If the head is installed on the machine, perform the following steps. If
the head is off the machine, go to step 2.
a.
Move the FlexJet Head Assembly to a maintenance position.
The machine cover must remain open during this procedure to place the
Interlock circuit in the violated state, disabling machine servo axes.
Failure to comply could result in serious personal injury.
b.
Palm down the machine and open the machine front cover.
c.
Remove the FlexJet Head Cover and the safety cover below the
hinged cover.
