Page 42
T47541109 Rev. J
FlexJet Head Assembly
TECHNICAL
PUBLICATIONS
This Document Supports Assembly 47541109 Rev. F
b.
Position the cursor over the
Set Outputs
button, but do not
select the button. This aids in selecting the button when the
spindle is in the proper lower position.
c.
Manually drive the spindle down by turning the Z-Axis Drive
pulleys and install a 10 MPF nozzle when the Coupler Body is
accessible.
d.
Continue to manually drive the pulley down until the nozzle tip is
+/- 0.05 inches (1,27 mm) from the shelf on the setup fixture.
Use new style fixture
Fixture
47768601
Coupler
Nozzle
Tip
Visually
Align with
Shelf Shown
e.
While holding the Z-Axis pulley in position, select the
Set
Outputs
button.
Adjust the Sensor
1.
Turn the vernier knob located on the Impact Sensor Setup Tool until it
comes in contact with the nozzle tip or use a 0.001 to 0.002 inches
(0,025 to 0,050 mm) feeler gauge.
2.
Teach the location for the selected spindle using the following
procedure.
a.
Remove the cover from Touch-Down Sensor for the selected
spindle. Refer to the following diagram.
Z-Safe
Sensor Assembly
Spindle Touch-Down
Sensor Assembly 1
b.
On the Spindle Touch-Down Sensor Assembly, set the
Mode
Selector
switch to
Teach
.
