Sun Microsystems StorEdge 6320 System 1.0, Справочное и сервисное руководство

Страница: 115 / 176

8-1
C H A P T E R
8
Removing and Replacing FRUs
Sun StorEdge 6320 systems are preconfigured with all the FRUs installed as specified
by the customer. This chapter describes the general instructions about how to install
and remove a FRU, the default configuration settings for the Sun StorEdge 6320
system, and the placement of the FRUs in the system.
Procedures to configure or modify the configuration of FRUs that have a software
component are described in the chapter associated with the specific FRU.
Caution –
FRUs in the system must be loaded from the bottom to the top to keep
the system center of gravity as low as possible. When servicing the system, remove
only one FRU from the system at a time. If possible, remove FRUs from top to
bottom to prevent raising the system’s center of gravity.
See
FIGURE 8-1
and
FIGURE 8-2
for the naming conventions and the placement of FRUs
in the system.
This chapter is organized as follows:
■
“Safety Requirements” on page 8-2
■
“FRU Locations” on page 8-3
■
“Installing and Removing a FRU” on page 8-5