Sun Microsystems StorEdge 6320 System 1.0, Справочное и сервисное руководство

Страница: 146 / 176

12-4 Sun StorEdge 6320 System 1.0 Reference and Service Manual • May 2003
12.2.1 Removing the Array
1. Turn off the two circuit breakers on the array that is being removed.
The circuit breakers are on/off switches located on each side of the array.
2. Remove the two power cables.
3. If a controller card is present, disconnect the Ethernet cable.
4. Disconnect the Ethernet cable from the keepers.
5. Disconnect and remove the two loop card cables from each side of the Sun
StorEdge 6020 array.
6. Remove the four screws that secure the Sun StorEdge 6020 array to the side rails
in the back.
7. Open the front door of the Sun StorEdge 6320 system.
8. Remove the trim strips from each side of the Sun StorEdge 6020 array.
9. Remove the four screws that attach the Sun StorEdge 6020 array to the Sun
StorEdge 6320 system.
10. Using two people, slowly push the Sun StorEdge 6020 array from the back of the
Sun StorEdge 6320 system.
The second person must be present to guide the array out from the front.
11. Set the array on a table and remove the eight screws that hold the side rails on
each side of the unit.
12. Remove all FRUs from the broken array that will to be used in the replacement
Sun StorEdge 6020 array.
The replacement Sun StorEdge 6020 array might be delivered to the site without all
the FRUs inside. Remove and save all the FRUs that will be reused. The five FRUs in
a Sun StorEdge 6020 include:
■
All disk drives
■
Loop cards
■
Controller card
■
Power and cooling unit
■
Battery