Sun Microsystems StorEdge 6320 System 1.0, Справочное и сервисное руководство

Страница: 122 / 176

8-8 Sun StorEdge 6320 System 1.0 Reference and Service Manual • May 2003
8.3.2 Removing a FRU
Required tools are:
■
Slotted screwdriver
■
No. 2 Phillips screwdriver
■
1/4-inch Allen wrench
To remove a FRU:
1. Remove the side panels, if necessary.
Refer to Section 7.3, “Removing and Replacing a Side Panel” on page 7-2 for a
description of removing the side panels.
2. For cabinets equipped with a front screen door, open the front screen door.
If it is necessary to remove the front door to remove a FRU, refer to Section 7.2,
“Removing and Replacing the Front Door” on page 7-2.
3. Remove the trim strips beside the FRU (
FIGURE 8-3
).
Use a No. 2 Phillips screwdriver to loosen the captive screws that attach the trim
strips to the system.
Save the trim strips for future use.
4. If the system is not mounted to the floor, extend the stabilizer legs.
The stabilizer legs are located under the front of the system.
Caution –
Always extend or retract the stabilizer legs as a pair. Make sure that the
levelers have been adjusted before attempting to move the stabilizer legs.
5. Remove the FRU.
Refer to Section 8.2, “FRU Locations” on page 8-3 for the location of FRUs in the
system.
6. If you are not replacing the FRU, install a filler panel over its previous location
(
FIGURE 8-3
).
Use a No. 2 Phillips screwdriver to tighten the captive screws.
Note –
To maintain proper airflow, make sure that you install filler panels over
locations that do not have FRUs mounted.
7. If necessary, retract the stabilizers under the system.