Sun Microsystems StorEdge 6320 System 1.0, Справочное и сервисное руководство

Страница: 119 / 176

Chapter 8 Removing and Replacing FRUs 8-5
8.3 Installing and Removing a FRU
This section contains general instructions about installing a FRU in the Sun StorEdge
6320 system cabinet. The steps required to install a particular FRU are contained in
the description of that FRU in subsequent chapters.
Required tools are:
■
Slotted screwdriver
■
No. 2 Phillips screwdriver
■
1/4-inch Allen wrench
■
9/32-inch nut driver
8.3.1 Opening the System to Access a FRU
1. Remove the side panels, if necessary.
Refer to Section 7.3, “Removing and Replacing a Side Panel” on page 7-2 for a
description of removing the side panels.
2. Determine where you are going to install the FRU.
Refer to the system Section 8.2, “FRU Locations” on page 8-3.
3. Open the back door of the Sun StorEdge 6320 system cabinet.
4. Remove the front door to install a FRU, if necessary.
Refer to Section 7.2, “Removing and Replacing the Front Door” on page 7-2.
5. Remove the filler panel located where you will install the FRU (
FIGURE 8-3
).
a. Use a No. 2 Phillips screwdriver to loosen the PEM fastener screws that attach
the panel to the system. The screws will remain attached to the filler panel.
b. Remove the filler panel and save it for future use.
Note – To maintain proper airflow, make sure that you install filler panels over
locations that do not have FRUs mounted.