Sun Microsystems Netra X4200 M2, Руководство по обслуживанию

Страница: 140 / 222

124 Netra X4200 M2 Server Service Manual • May 2007
POST Codes
TABLE B-1
contains descriptions of each of the POST codes, listed in the same order in
which they are generated. These POST codes appear as a four-digit string that is a
combination of two-digit output from primary I/O port 80 and two-digit output
from secondary I/O port 81. In the POST codes listed in
TABLE B-1
, the first two
digits are from port 81 and the last two digits are from port 80.
TABLE B-1
POST Codes
Post Code Description
00d0 Coming out of POR, PCI configuration space initialization, Enabling 8111’s SMBus.
00d1 Keyboard controller BAT, Waking up from PM, Saving power-on CPUID in scratch CMOS.
00d2 Disable cache, full memory sizing, and verify that flat mode is enabled.
00d3 Memory detections and sizing in boot block, cache disabled, IO APIC enabled.
01d4 Test base 512KB memory. Adjust policies and cache first 8MB.
01d5 Boot block code is copied from ROM to lower RAM. BIOS is now executing out of RAM.
01d6 Key sequence and OEM specific method is checked to determine if BIOS recovery is
forced. If next code is E0, BIOS recovery is being executed. Main BIOS checksum is tested.
01d7 Restoring CPUID; moving boot block-runtime interface module to RAM; determine
whether to execute serial flash.
01d8 Decompressing runtime module into RAM. Storing CPUID information in memory.
01d9 Copying main BIOS into memory.
01da Giving control to BIOS POST.
0004 Check CMOS diagnostic byte to determine if battery power is OK and CMOS checksum is
OK. If the CMOS checksum is bad, update CMOS with power-on default values.
00c2 Set up boot strap processor for POST. This includes frequency calculation, loading BSP
microcode, and applying user requested value for GART Error Reporting setup question.
00c3 Errata workarounds applied to the BSP (#78 & #110).
00c6 Re-enable cache for boot strap processor, and apply workarounds in the BSP for errata
#106, #107, #69, and #63 if appropriate.
00c7 HT sets link frequencies and widths to their final values.
000a Initializing the 8042 compatible Keyboard Controller.
000c Detecting the presence of Keyboard in KBC port.
000e Testing and initialization of different Input Devices. Traps the INT09h vector, so that the
POST INT09h handler gets control for IRQ1.
8600 Preparing CPU for booting to OS by copying all of the context of the BSP to all application
processors present. NOTE: APs are left in the CLI HLT state.