97
96
Checking clutch hydraulic fluid level
Topping off the clutch hydraulic fluid level
- Place the master cylinder horizontally.
- Check the level through window
1
.
- Loosen the two screws
1
- Remove the cap
2
and its diaphragm
3
- Fill the reservoir with DOT 4 brake
fluid.
- Replace the diaphragm
3
, the cap
2
and
the two screws
1
.
Warning
:
- Hydraulic fluid is highly corrosive, it can de harmful to the skin.
- Please read the recommendations on the container.
The level should be between the two arrows
Adjust the level if necessary
1
1
2
3
!
MIN
Diagram :
- Remove the filter with its housing.
- Separate the filter from its housing.
- Clean the filter foam with a suitable
detergent. (NEUTRAL)
Do not use solvent or petrol !
- Dry the filter element.
- Spray the air filter with
AIR FILTER oil until it achieves a uni-
form blue color.
- Replace the filter element in its housing
with care Make sure that the three lugs
G
are properly located
- Apply a thin film of grease to the
air filter seal.
- If necessary clean the inside of the air
chamber with a cloth.
- Replace the filter and its housing, taking
care to centre it correctly.
- Replace the blocking part
B
(See page 95)
by inserting it first into the filter
assembly and then into the support
D
(See page 95).
Replace the seat forwards, making sure that
the recess
E
is located in the tab
F
of the
tank and the tongue is under the tank.
Lock the screw by turning it one quarter turn
clockwise.
F
E
G
G
G
