Allstar Performance 8300 Lane Dr., Watervliet, MI 49098
Phone: (269) 463-8000 Fax: (800) 772-2618 www.allstarperformance.com
Form 1174
Page 1 of 4
Rev. 050219
INSTALLATION INSTRUCTIONS
Tear-Off Machine
NOTE: We recommend installation on a new unscratched shield.
WARNING: Velcro adhesive might not stick properly to older shields due to scratch proof coating peeling off
due to age.
1.
The following instructions are for a new shield with protective film on both sides. If shield does not
have the protective film cover shield with a clear food wrap to protect during installation.
2.
Sit in vehicle with helmet on your head and using a marker place a small mark to identify the
horizotal center point of eyes. This is the comfortable height at which you will look out of the shield
while sitting in the race car seat. Transfer marks to the backside of shield also for later use.
3.
Remove shield from helmet, then remove pegs that hold manual tear offs if applicable.
4.
Mark the vertical centerline of shield using tape measure. This is the center from right to left. Transfer
these marks to the backside of shield for later use.
5.
Using a pinch type clamp, clamp the tear-off machine to the center point of your shield. Make sure
protective material is used to prevent damage to the shield or tear-off machine.
6.
By hand, hold each end of guiding system tight to shield and verify that the 2 outside quick release
mounting points are within the shield.
Tear-Off Machine to Shield Installation
Clear Film Housing
(New Film)
Mud Scraper
Black Aluminum Film
Housing (Used Film)
Film Guide Lens,
Inner and Outer
