Page 1
Installing the Cutter Kit
ITEM "A"
SCREW
ITEM "B" SCREWS
ITEM "A"
ITEM "B"
STEP
PROCEDURE
1.
Switch the printer
OFF
and disconnect the power cord.
2.
Raise the top cover and print head assembly.
3.
Refer to the illustrations on the following pages.
Remove the front door panel.
4.
Raise the tear bar to the upright position.
5.
Insert the connector from Item "B" into CN3 on the printer.
6.
Install Item "B" by placing the tabs in and down into the slots on the
printer. Be sure the positioning holes on Item "B" are inserted on the
positioning pins. Secure with (2) Item "B" screws.
7.
Lower the tear bar to the operating position.
8.
Secure Item "A" to the print head with Item "A" screw. Lever on Item
"A" swings down to unlock and up to lock and pivots forward in the
unlocked position.
9.
Lower the print head assembly and replace the front door panel and top
cover.
10.
Set the dip switch settings to the cutter mode.
1
W
S
D
2
W
S
D
3
W
S
D
G
N
I
T
T
E
S
f
f
O
n
O
f
f
O
e
d
o
M
r
e
t
t
u
C
