93
92
Warning
:
With the engine cold check the cooling fluid level and top up if necessary.
Do not check when the engine is hot as the hot liquid can cause severe injuries.
- Cooling liquid is poisonous:
In the event of contact with the skin or the eyes, or ingestion, or injuries
caused by hot liquid:
CONSULT A DOCTOR
- Use protective gloves.
- Use cooling liquid Radiator Liquid Ref: 500
- Always use pre-mixed coolant.
NOTE : To protect the environment, deposit your purged liquid at a collection
center.
Remove the radiator cap
5
- Check that the cooling liquid level is
approximately 10mm above the radiator
tubes.
To top up the coolant:
- Place the bike on the side stand
- Loosen the bleed screw
4
- Adjust the level
- Replace screw
4
- Tighten (see torque table)
- Replace the cap
5
and make sure it is
seated correctly
1
Thermostat
2
Pump
3
Radiator
4
Radiator bleed screw
Checking the level:
Make sure that your bike is
vertical and on a horizontal surface.
3
2
5
1
4
!
Right hand side
Left hand side
Diagram :
Cooling system:
Cooling
Replacing a headlight or driving light bulb
- Remove the rubber protection
A
.
- Turn the pin
B
,
- Withdraw the headlight unit.
- Press lightly on the bayonet bulb, and turn counter clockwise to remove.
- Reverse the procedure to re-assemble.
- The drinving light
C
is easily replaced by removing the bulb holder from the
reflector.
Warning
:
- Always use bulbs with the right wattage.
Release the headlight plate upwards.
Reassembling the headlight plate
Reverse the removal procedure.
Make sure that the lugs
1
on the headlight
plate are securely in the holes
2
in the
front mud guard.
The headlight plate can be removed very quickly.
Just unclip the left and right rubbers either side of the forks
1.
Removing the headlight plate
A
C
1
1
2
B
!
!
Refill
Control
On bike stand
Horizontal
10 mm
Warning : It is extremely important
to follow tuese instructions carefully.
Incorrect coolant levels can cause serious
damage to tue engine.
