Rohde & Schwarz 1065.6000.20, Руководство по эксплуатации

Страница: 245 / 438

SENSe Subsystem FSE
1065.6016.12 6.188 E-16
:[SENSe<1|2>:]DDEMod:SEARch:SYNC:DELete <string>
This command deletes a synchronization pattern on the hard disk. This sync file must be previously
selected by the command
DDEM:SEARch:SYNC:NAME
.
Example:
":DDEM:SEAR:SYNC:DEL
Features: *RST-value: ""
SCPI: device-specific
Mode: VA-D
:[SENSe<1|2>:]DDEMod:SEARch:SYNC:MONLy ON | OFF
For setting ON, this command sets the analyzer so that the measured values are displayed and
taken into account in the error analysis only if the set sync pattern is found . Bursts with a wrong sync
pattern (sync not found) are ignored. If an invalid sync pattern is found or if there is none, the
measurement is halted and continued in the presence of a valid sync pattern.
This command is available only if the search for a synchronization sequence is activated
(
DDEM:SEARch:SYNC:STATe = ON).
Example:
":DDEM:SEAR:SYNC:MONL ON"
Features: *RST value: OFF
SCPI: device specific
Mode: VA-D
:[SENSe<1|2>:]DDEMod:SEARch:TIME 100 to 1600
This command determines the number of symbols required for demodulation (frame length). The
values > 800 are only permissible if the number of points per symbol is <16, the values > 1600 only if
the number of points per symbol is <8. Step width is 100.
Example:
":DDEM:SEAR:TIME 800"
Features: *RST value: 400
SCPI: device-specific
Mode: VA-D