ROBBE-Futaba FX-32, Инструкция по эксплуатации

Страница: 143 / 180

143 <Model Menu (Airplane/Glider Functions)>
● S e l e c t t h e f u n c t i o n
name and return to the
preceding screen by
touching the RTN button
or pushing the Home/Exit
button.
<SensorTouch™>
ELEVATOR
(RUDDER 2)
RUDDER
(ELEVATOR 2)
V-TAIL
[Corresponding model type]: Airplane/glider, V-tail
This function let’s you adjust for left and right
rudder angle changes at elevator and rudder
operation of a V-tail airplane.
V-tail is when 2 servos are used together to
control rudder movement as elevators. In addition
to each rudder side moving up and down together,
each side moves in opposite directions when moving
as elevators. On a V-tail, this is also known as a
ruddervator, as they can serve the same purpose.
(Rudder function)
L e f t a n d r i g h t t r a v e l
adjustment at CH1 and CH2
rudder operation
● Group/single mode switching
(For more information, see the description
at the back of this manual.)
(Elevator function)
Up and down travel adjustment at
CH1 and CH2 elevator operation
(Currently selected condition name)
● Select [V-TAIL] at the model
menu and call the setup screen
shown below by touching the
RTN button.
● Travel adjustment
Move the cursor to the item you want to
adjust and touch the RTN button to switch
to the data input mode.
Adjust the rate by scrolling the touch sensor.
Touch the RTN button to end adjustment
and return to the cursol move mode.
*If the mixing direction is reversed by the linkage,
adjustments can be made by changing the mixing rate
polarity (+ or -).
*If a large value of travel is specified, when the sticks are
moved at the same time, the controls may bind or run out
of travel. Decrease the travel until no binding occurs.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value