79
<Functions of Linkage Menu>
● Select the function name
and return to the Linkage
menu by touching the
RTN
button or pushing the
Home/Exit
button.
<SensorTouch™>
THROTTLE CUT
Stops the engine safely and easily.(airplane and helicopter only)
Throttle cut provides an easy way to stop the
engine, by flipping a switch with the throttle stick
at idle. The action is not functional at high throttle
to avoid accidental dead sticks. The switch’s
location and direction must be chosen, as it defaults
to NULL.
Throttle cut setting procedure
*Perform the following settings before using the touch sensor
to move the cursor to the item to be set.
1. Activate the function:
Move the cursor to the [ACT/INH] item and
touch the RTN button to switch to the data
input mode.
Turn the touch sensor to the left until the
blinking changes from "INH" to "ACT" and
then touch the RTN button.
2. Switch setting:
Move the cursor to the [SWITCH] item and
call the switch setup screen by pressing the
RTN button and select the switch and ON
direction.
(For a detailed description of the setting method, see [Switch
Setting Method] at the back of this manual.)
3. Throttle cut position setting:
Move the cursor to the [CUT POSITION] item
and touch the RTN button to switch to the
data input mode.
Adjust the servo operation position at throttle
cut operation by turning the touch sensor to
the left or right.
Initial value: 17%
Adjustment range: 0%~50%
(When the RTN button is pressed for 1 second, the servo
operation position is reset to the initial value.)
Touch the RTN button to end adjustment and
return to the cursol move mode.
*With the selected cut switch ON and the throttle stick at idle;
adjust the rate until the engine consistently cuts off.
However, be sure that the throttle linkage is not pulled too
tight and unreasonable force is not applied to the servo.
● Select [THROTTLE CUT] at the linkage menu and
call the setup screen shown below by touching
the RTN button.
● Current throttle position
● Cut position
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
Содержание FX-32
Страница 1: ...Instruction Manual FX 32 No F8078 ...
Страница 9: ...9 Introduction Notes ...
