53
<Model Basic Setting Procedure>
1. Model addition and call
Default setting assigns 1 model to the FX-32. To
add new models or to call a model already set, use
the Model Select function of the Linkage Menu.
This is convenient when calling a model after
registering the model names in advance. (The data
of up to 30 models can be saved at the transmitter.
Data can also be saved to the optional SD card.)
The currently called model is displayed at the top
of the screen. Before flying and before changing
any settings, always confirm the model name.
When a new model is added, the Model Type
Select screen and Frequency/Modulation mode/
Receiver ID setup screen automatically appear.
Change, or check that they match the type,
frequency, and receiver type of the model used.
2. Model type and swash type selection
If a different model type is already selected,
select helicopter with the Model Type function of
the Linkage Menu, and then select the swash type
matched to the helicopter.
*The Model Type function automatically selects the
appropriate output channels, control functions, and mixing
functions for the chosen model type. Eight swash types are
available for helicopters.
Helicopter basic setting procedure
This section outlines examples of use of the helicopter functions of the FX-32. Adjust the actual values,
etc. to match the fuselage used.
*For a description of the swash type selection, refer to the
MODEL TYPE function.
3. Flight condition addition
The transmitter can install up to eight flight
conditions per model.
The Condition Select function automatically
allocates five conditions for helicopter.
(Initial setting)
● NORMAL
● IDLE UP1 (SW-E)
● IDLE UP2 (SW-E)
● IDLE UP3 (SW-F)
●HOLD (SW-G)
Note: Since you may accidentally activate
the conditions that has not been setup during
flight and this could cause a crash, delete
the conditions not used.
*For a description of the condition deletion, refer to the
COND. SELECT function.
The NORMAL condition is always on, and remains
on until other conditions are activated by switches.
The priority is throttle hold/idle up 2/idle up 1/
normal. Throttle hold has the highest priority.
Add other conditions, as required.
The Condition Delay can be programmed for each
channel. The Condition Delay is used to change the
servo throw smoothly when switching conditions.
(General flight condition setting example)
● Normal: (Use initial setting conditions/operate
when switch OFF)
Use from engine starting to hovering.
● Idle up 1: (Operate at SW-E center)
Use in 540º stall turn, loop, rolling stall turn, and other
maneuvers.
● Idle up 2: (Operate at SW-E forward side)
Use in rolls.
● Throttle hold: (Operate at SW-G forward side)
Use in auto rotation.
Содержание FX-32
Страница 1: ...Instruction Manual FX 32 No F8078 ...
Страница 9: ...9 Introduction Notes ...
