ROBBE-Futaba FX-32, Инструкция по эксплуатации

Страница: 151 / 180

151 <Functions of Model Menu (Helicopter Functions)>
● S e l e c t t h e f u n c t i o n
name and return to the
p r e c e d i n g s c r e e n b y
touching the RTN button
or pushing the Home/Exit
button.
<SensorTouch™>
PIT CURVE/PIT TRIM
PIT Curve
This function adjusts the pitch operation curve
for each flight condition for the optimal flight state
relative to movement of the throttle stick.
*Up to 17 points can be set for the point curve types.
However, when using the 3 points or 5 points specified to
create a curve, a simple curve can be created by reducing
the number of input points to 3 or 5, and then entering the
specified value at the corresponding points that you created
a curve.
● Point curve type is 9 points
(initial), but for simple use,
4~5 points are sufficient.
Normal curve adjustment
● For normal curve, usually use [POINT] type
and create a basic pitch curve centered
about hovering. Use this function together
with the THR curve (normal) function and
adjust the curve so that up/down control is
best at a constant engine speed.
Idle up curve adjustment
● For the high side pitch curve, set the
maximum pitch which does overload the
engine. For the low side pitch curve, create
curves matched to loop, roll, 3D, and
other purposes and use the idle up curves
according to the performance.
Throttle hold curve adjustment
● The throttle hold curve is used when
executing auto rotation dives.
Operation precautions
WARNING
When actually starting the engine and flying,
always set the idle up condition switch to OFF
and start the engine in the idling state.
(Currently selected condition name)
● Select [PIT CURVE] at the model menu
and call the setup screen shown
below by touching the RTN button.
● G r o u p / s i n g l e m o d e
switching
(For more information, refer to
the description at the back of this
manual.)
● Mixing curve setting
*For a description of the curve setting method, see the
description at the back of this manual.
● Pitch servo speed setting
(For a description of the setting
method, see the description at the
back of this manual.)
● Pitch trim copy
● Pitch trim operating
position (dotted
line)
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page