ROBBE-Futaba FX-32, Инструкция по эксплуатации

Страница: 159 / 180

159 <Functions of Model Menu (Helicopter Functions)>
● S e l e c t t h e f u n c t i o n
name and return to the
p r e c e d i n g s c r e e n b y
touching the RTN button
or pushing the Home/Exit
button.
<SensorTouch™>
SWASH MIX
The swash mix function is used to correct the
swash plate in the aileron (roll) direction and
elevator (cyclic pitch) corresponding to each
operation of each condition.
Adjustment by independent curve for aileron,
elevator, and pitch operations is possible. The
operation can be smoothly adjusted by calling up
the “Curve setup” screen by touching the EDIT
button with moving the cursor to the mixing item
that corresponds to the mixing and direction which
needs correction.
Example of use
● As an example, use swash mixing to correct
undesirable tendencies in the roll direction
● For a condition which uses AIL to ELE, set this
function to ON. When raising the nose at a
right roll, when the Rate B side is input and
the right aileron is operated, the elevator
moves to the down side. Tune by adjusting
the Rate. For right roll, adjust to the rate A
side.
Setting method
● When using this function, move the cursor
to the [ACT] item and touch the RTN button
to switch to the data input mode. Turn the
touch sensor to the left and touch the RTN
button. (ON is displayed.)
● When you want to set the same contents at
other conditions, select the group mode.
When you want to set the selected condition
only, select the single mode (initial setting).
● The correction rate can be set by curve.
● A switch can be set.
When [ [--]] is set, the swash mixing function is
operated by merely selecting the condition.
When setting an [ON]/[OFF] switch, move
the cursor to the [--] item and touch the RTN
button to call the selection screen and set
the switch and its ON position.
(Currently selected condition name)
● Select [SWASH MIX] at the model
menu and call the setup screen shown
below by touching the RTN button.
● G r o u p / s i n g l e m o d e
switching
(For more information, refer to
the description at the back of this
manual.)
● Mixing curve setting
*For a description of the curve setting method, see the
description at the back of this manual.
Scrolling
● Moving cursor
● Selecting mode
● To next page