Ricoh InfoPrint 4100 TD3, Руководство по эксплуатации

Страница: 440 / 462

v
Finished Weight (with ink and varnish) = 157 pound text, offset, or book = 63
pound bond/233 gsm maximum
v
Caliper = 0.0092 inches, maximum
v
Porosity = 80 through the Gurley measurement system using mercury
v
Smoothness = 2.5 Parker print surface rating
v
Description = Coated freesheet (free of groundwood), matte or gloss finish
This feature is available on InfoPrint Models HS2, HS3, HD3/4, and HD5/6. It
provides hardware that increases the ability for toner to fuse on this type of paper
stock. A PTFE mat is provided for InfoPrint Models HD4 and HD6. The mat
prevents toner from sticking to the pre-heat platen. The PTFE mat and wear strip
are installed only in Printer 2 in a duplex system. A starter set of mats and wear
strips is supplied. Additional mats and wear strips are available as a supply item.
The PTFE mat helps prevent a build up of toner, ink, and other substances on the
preheat platen. Included with this feature is a wear strip that can improve the life
of the PTFE mat. In some applications, the PTFE wear strip may cause fusing
problems. If this is a problem, you can remove the wear strip.
The customer must provide any additional pre- and postprocessing equipment
needed to handle commercial print forms. This may include urge units, walkovers,
and other paper path modifications. An urge unit is required when printing in
duplex mode with heavyweight forms when using this feature. It is also the
customer's responsibility to order additional PTFE mats and wear strips as a
supply item.
Installing and removing the PTFE Mat and PTFE wear strips
Do these tasks when the PTFE mat shows obvious signs of wear or damage, or
you start getting offset on prints.
This section describes the following procedures:
v
Installing the PTFE mat and wear strip.
v Removing the PTFE mat and wear strip assembly.
You need the following items when you install or change the PTFE mat and PTFE
wear strip on the InfoPrint 4100:
v
PTFE mat - one package (four PTFE mats per package)
v
PTFE wear strip for all models - one package (4 PTFE wear strips per package)
v
Mat lifter tool
v
Cellophane tape
Refer to the “Supplies Work Sheet” in Appendix A. Obtaining Supplies of the
Planning and Configuration Guide for the part numbers for these supplies.
Installing the PTFE mat and wear strip
Before you begin
Printer 1 and Printer 2 must be powered off before you start this task.
426
Operating the InfoPrint 4100