Ricoh InfoPrint 4100 TD3, Руководство по эксплуатации

Страница: 57 / 462

v
The initial microcode load (IML) sequence is complete on the system control
unit.
v
The transfer station and all gates are closed and latched.
v
All supplies are loaded.
v
The fuser is warmed up.
v
No errors are present.
v
All enabled preprocessing and postprocessing devices are powered on and
ready.
v The Start key on the printer operator panel or the Start button on the Main
touch panel has been selected.
Operator intervention (Not Ready status)
When normal operation is interrupted, the printer goes into a Not Ready state. Any
of the following actions can cause a Not Ready state:
v
Selecting the Stop button on the Main touch panel.
v
Pressing the Stop key on the printer operator panel.
In addition, whenever the printer detects an intervention condition, it places itself
in
Not Ready status. It also displays an error message on the touch panel and the
printer operator panel display. The following types of interventions cause a Not
Ready status:
v
The printer needs basic supplies service. For some supplies, you can temporarily
bypass this message and continue processing; other supplies require you to
replace them immediately.
v
The printer needs basic service that involve forms handling or checking on
mechanical conditions, such as an open gate. You must handle all messages of
this type immediately.
v
The printer or the control unit has a hardware problem, such as a forms jam or a
component failure. Processing stops so that you can attempt to correct the
problem, or, if necessary, call for service. You can postpone action for some
messages of this type; others you must handle immediately. Some printed pages
may be lost or damaged because of printer errors.
Related information:
“Responding to messages” on page 215
Chapter 2. Operator's overview
43