Ricoh InfoPrint 4100 TD3, Руководство по эксплуатации

Страница: 155 / 462

Adjusting the printer for new forms
About this task
Do this procedure to adjust the printer for new forms after feeding new forms
through the printer. By adjusting the printer for the new forms, you can avoid
receiving error messages associated with the change.
Procedure:
Procedure
1. Use the Tractor Control Knob (6) to adjust the tractors close the correct width.
Use the scale just to the left of the tractor covers.
2.
If your new forms are tractored, locate the red line on the lower tractor. Place
the forms on the tractor pins so that the form edge is as close as possible to
the red line without covering it. If necessary, use the
Tractor Control Knob to
adjust the distance between the front and rear tractors:
v
To increase the distance, turn the Tractor Control Knob clockwise .
v
To decrease the distance, turn the Tractor Control Knob counterclockwise .
When the tractors are adjusted correctly, a sheet of forms should drop easily
onto the tractor pins and lay flat. The pins should be centered in the tractor
holes, without binding. Verify that the forms are aligned correctly on the
tractor pins.
3. If you are using tractorless forms, adjust the tractorless feeding unit (drive
roller, pressure roller, and vacuum belt unit slots
(1) ) to the same position
according to the following:
v
Slot 1 – 8 in. to 10.4 in. paper width
v
Slot 2 – 10.5 in. to 13.4 in. paper width
v
Slot 3 – 13.5 in. to 16.4 in. paper width
v
Slot 4 – 16.5 in. to 19.5 in. paper width
4. Adjust all tractor units. Make sure the tractor slot (2) is in the tractorless feed
mode (3) for tractorless forms or position (4) for tractored forms.
a. To adjust a unit, press the blue button (5) while grasping the unit and slide
the unit to the correct position.
Chapter 5. Working with forms
141