Ricoh InfoPrint 4100 TD3, Руководство по эксплуатации

Страница: 138 / 462

2. If the name listed in the Form Name field contains the form definition you
want to load, select Cancel .
3. If the name listed in the Form Name field does not contain the form definition
you want to load, do the following:
a. Ensure that the length and width values are correct.
b. Select Frequent Tasks → Snapshots . You see a list of the currently defined
Snapshots.
c. If you are loading a Snapshot that has been previously defined, select the
Snapshot you want to load from the
Saved Snapshots area, and select Load .
Note: If the Snapshot is not defined, see Chapter 4, “Working with Snapshots,”
on page 61 for more information about defining Snapshots.
What to do next
If you are using the Auto Load sequence to load the forms, you must set the forms
length at the stacker control panel. See “Setting the forms length for Auto Load”
on page 134. If you are loading the forms manually, see “Loading forms using the
Forms Feed button” on page 82.
Loading forms using the Forms Feed button
Before you begin
Hold the tension arm so that it stays aligned with the blue mark on the guide
notch while you do the following steps. Otherwise, the 079A
CHECK TENSION ARM
9:56
6/28/11
g5aud258
Frequent
Tasks
Forms Maintenance
Printer
Definition
Logon...
Units
mm
in
Width
11.0
18.0
Length
Form Name
0
0
2UpLetter
Form Bar Code
Align Forms
Form Settings
Help... OK
Start Stop Check/Reset
Tractorless Marks...
Oversize paper No
Paper Weight
75 - 98 gsm (20 - 26 pounds)
Cancel
Advance
Paper (NPRO)
Shutdown
Print
Registration
Print
Registration
IPDS
Advance
Paper (NPRO)
Special Marks
Tractorless (Tractored
Forms)
Host Setup
Id
Enable
NO
Commercial Print
Figure 46. Form Settings panel
124
Operating the InfoPrint 4100