Ricoh InfoPrint 4100 TD3, Руководство по эксплуатации

Страница: 94 / 462

a. Loosen the thumbscrew (2) .
b.
Slide the rear paper-edge guide (1) to the correct location for the current
paper width. The paper should be positioned against the vertical surface of
the guide
(3) so that the sensor on the bottom side of the sensor mounting
plate can read side verify marks and registration marks, which are printed
on the outside edge of the paper. The edge guide is also used to guide the
paper in tractorless mode.
c. Tighten the thumbscrew (2) .
Note: The thumbscrew (4) adjusts the position of the sensor on the bottom
side of the sensor mounting plate. It must be turned fully counterclockwise
to position the sensor to read the side verify or registration marks at the
outside edge of the paper (this is the default position). If you change the
location of the marks (
Forms
→
Special Marks ), you must adjust the
position of the sensor.
10. See “Adjusting the Universal Forms Control (UFC) sensor” on page 199 or
“Adjusting the rear paper-edge guide and Dual Toner Mark/Side Verify
Sensor” on page 146 for more information.
What to do next
If you are changing to a different size form on Printer 1, you must change the
forms on Printer 1. See “Changing forms settings on Printer 1” on page 81. If you
are using the Auto Load sequence to load the forms, you must set the form length
at the stacker control panel. See “Setting the forms length for Auto Load” on page
134.
2
3
1
4
11
12
11
12
g6am0024
11
12 12
80
Operating the InfoPrint 4100