Ricoh InfoPrint 4100 TD3, Руководство по эксплуатации

Страница: 269 / 462

Chapter 7. Cleaning and Servicing the printer
About this task
This section describes how to:
v
Clean various areas of the printer and Buffer/Flipper units
v Clean various sensors
v
Add supplies like fuser oil, toner, and developer mix
v
Check the toner collector and change the toner collector waste bag
v
Check and change the fine filer
v
Clean and change the oiler belt
v
Check the absorbent pad in the oil pan
v
Replace the customer-replaceable corona wires
Clean the following areas of both printers before each shift:
v Developer area and corona wires
v
Forms input area
v Transfer station area
v
Stacker area
v
Early drum jam sensor and Universal Forms Control (UFC) sensor
v
Buffer/Flipper unit
v
Rear service area
Clean the following area at least once each week:
v
Oiler belt.
Recommendations About Cleaning the Printer
v
Clean the printer before each shift or more often if necessary.
v
The following procedure specifies that you unload forms from the printer before
you clean.
– Unloading forms before cleaning requires reloading the forms after cleaning.
– Loading forms is a time-consuming activity and requires flushing forms out
of the entire forms path, then reloading and threading the entire forms path.
– We recommend that for normal, once-per-shift cleaning of the printer you
leave forms loaded on the printer, and do the best job you can working
around the forms. We also recommend that you do an additional cleaning
when you load a new type of form or when you have cleared the forms path.
DANGER
hcsf0115
To vacuum toner, use only an approved vacuum cleaner. <1-15>
255