Ricoh InfoPrint 4100 TD3, Руководство по эксплуатации

Страница: 227 / 462

Verify sensor in Duplex mode” on page 408 for information about configuring the
printer to use the appropriate sensor when printing on preprinted forms in
tractorless mode.
Procedure:
Procedure
1. Select Forms
→
Special Marks to display the Special Marks panel.
2. Select Registration Marks for Top of Form in the Special Marks window.
3. If you want to make changes to the registration mark, select Edit... to display
the Edit window and use the following fields to change the size or location of
the mark.
v
In the
Enabled
field, select the printer you want to print the marks.
v
Across Paper Feed Direction provides options to set the width of the mark,
the alignment of the mark relative to the front or back edge of the form, and
the offset relative to the alignment value.
v
Paper Feed Direction provides options to set the height of the mark and the
placement of the mark relative to the top of the form.
4. Select OK to save your changes.
Related information:
“Using the Dual Toner Mark/Side Verify Sensor (FC 4570/9570)” on page 407
“Selecting the Universal Forms Control (UFC) sensors” on page 198
Use these instructions to select which UFC sensor you want to adjust. Choosing
the lower mark sensor reads the front of the forms; choosing the upper mark
sensor reads the back of the forms. This function is only available in
Administrator or Service mode.
Using registration marks for UP3I synchronization
About this task
Do this procedure to define or specify registration marks used for UP3I device
synchronization. Use the Edit window to change the size and location of the mark.
When using the UP3I registration mark, a black rectangular mark is printed at the
location specified in the Edit window. This mark is used to ensure the pages are
synchonized as they are processed by the UP3I devices. The mark is printed after
events such as a paper jam to help ensure page synchronization.
Note: Registration marks are placed relative to the physical edge of the form to
allow printing the mark in the tractor strips on tractored forms. The marks are
printed in the same location on tractorless forms.
Procedure:
Procedure
1.
Select
Forms → Special Marks
to display the Special Marks panel.
2. Select Registration Marks for UP3I in the Special Marks window.
3.
If you want to make changes to the registration mark, select
Edit...
to display
the Edit window and use the following fields to change the size or location of
the mark.
Chapter 5. Working with forms
213