Ricoh InfoPrint 4100 TD3, Руководство по эксплуатации

Страница: 294 / 462

Do this procedure when you see the 0792
ADD FUSER OIL
or 079D
OIL LEVEL LOW
message.
Note: You do not have to replace fuser oil the first time you see the
ADD FUSER OIL
message. To bypass the message, select Start on printer operator panel or on the
Main touch panel.
The ADD FUSER OIL message reappears each time end-of-forms is reached, or every
4 000 feet of forms thereafter if you are using a roll-feed preprocessing device.
When certain additional feet of forms have been processed since the message
originally appeared, you
must add fuser oil before you can return the printer to
Ready status.
Attention:
Using the wrong fuser oil causes print quality problems. Refer to the “Supplies
Work Sheet” in Appendix A. Obtaining Supplies in the
Planning and Configuration
Guide for the correct part number.
Procedure
1. Open the center rear and left rear covers of the printer.
2. Remove the cap from the oil reservoir. Put the cap in a safe place.
3. Locate a bottle of fuser oil and a plastic spout. (Every new package should
contain a bottle of fuser oil and a plastic spout.)
4. Ensure that the spout is clean.
5.
Remove the bottle lid and the inner seal.
6. Screw the spout onto the bottle of fuser oil.
7. Bend the spout and carefully place it into the oil reservoir opening.
Tip:
When you add fuser oil, be careful to pour slowly . A filter in the reservoir
restricts the flow of fuser oil.
8. Tip the bottle to let the fuser oil drain into the oil reservoir.
280
Operating the InfoPrint 4100