Ricoh InfoPrint 4100 TD3, Руководство по эксплуатации

Страница: 149 / 462

The automatic loading process does the following:
v
Raises the auto load bridge.
v
Lowers the tension arm.
v
Passes the forms through the transfer station, across the tension arm and
bridge, and into the fuser entry area.
v
Moves the forms into the forms exit area.
After a slight pause, the automatic loading process does the following:
v
Adjusts the tension-arm position.
v Lowers the auto load bridge.
Note:
If a forms jam occurs during the Auto Load sequence, see “Clearing
forms jams” on page 230.
2. Ensure that the tension arm is aligned correctly. The mark on the tension arm
(1) should be visible in the notch in the transfer station frame. See “Checking
the tension arm” on page 147.
3. At the transfer station, ensure that the perforation is aligned with the correct
forms length (the forms length set at the stacker control panel). For example,
forms that are 11 inches long should be aligned so that the perforation is at the
11-inch mark. The forms length must be set as follows:
v For forms that are 7 inches or greater - set the forms length to the actual
length of the form.
v
For forms that are 3-1/2 to 6-2/3 inches - set the forms length to two times
the actual length of the form.
Toner
Mark
Reverse
Auto Load Forms Set Forms Feed
Load STOP Forward
IC3U0032
Figure 51. Auto Load - Load key on the printer control panel
R4CO0070
1
Chapter 5. Working with forms
135