Ricoh InfoPrint 4100 TD3, Руководство по эксплуатации

Страница: 136 / 462

The first tractor hole on the front edge of the tractored form should be on the
upper tractor pin
directly across from the pin holding the first tractor hole on
the rear edge of the form.
11.
Close the upper tractor covers.
12. Gently push the transfer station toward the photoconductive drum until it
locks securely into position.
13. Remove any slack from the forms and place the forms on the lower tractor
pins, if using tractored paper.
14. Remove any slack from the forms and place the forms on the lower tractor
pins, if using tractored paper.
15. Close the lower tractor covers.
16.
Adjust the rear paper-edge guide as follows:
Note: This step applies to InfoPrint Models MS1, HS2, HS3, MD1/2, HD3/4,
and HD5/6 when the Dual Toner Mark/Side Verify Sensor feature (FC 4570)
is installed.
a. Loosen the thumbscrew (2) .
b. Slide the rear paper-edge guide (1) to the correct location for the current
paper width. The paper should be positioned against the vertical surface of
the guide
(3) so that the sensor on the bottom side of the sensor mounting
plate can read side verify marks and registration marks, which are printed
on the outside edge of the paper. The edge guide is also used to guide the
paper in tractorless mode.
c. Tighten the thumbscrew ( 2 ).
2
3
1
4
11
12
11
12
g6am0024
11
12 12
122
Operating the InfoPrint 4100