Ricoh InfoPrint 4100 TD3, Руководство по эксплуатации

Страница: 179 / 462

5. Open the left and center covers of Printer 2.
6.
Press the Forms Feed Reverse or Forms Feed Forward buttons (3) on the
operator panel until the dashed alignment mark lines up with the end of the
ruler at or near the 17" mark
(4) .
7. Select OK at the verification touch panel. The solid alignment mark on the
alignment page automatically aligns with the ruler.
8.
Visually verify that the solid alignment mark printed on Printer 1 is aligned to
the correct form length mark on the input station alignment scale on Printer 2.
If the alignment mark is aligned at Printer 2, check to see if there are enough
forms between Printer 1 and the Buffer/Flipper Unit. If you need to increase
the buffer loop, change the "Printer 1 to Printer 2 Distance" printer
configuration item. See the item in the Printer Configuration Items table in the
Planning and Configuration Guide for more information.
9. If a postprocessing device is installed and not threaded, select Advance Paper
(NPRO) , or select the appropriate paper advance (feed page) key on the Align
Forms panel or on either printer operator panel, as many times as necessary
to advance the forms enough to thread the postprocessing device.
10. Select OK to close the panel.
11.
Select
Start
on the printer operator panel or on the Main touch panel to begin
printing.
c0tu019
1
5
5
4
2
3
Chapter 5. Working with forms
165